Table of Contents
Advertisement
installation & connection
inStaLLation (Sno-L6013r/Sno-L6083r)
This camera is waterproof and in compliance with the IP66 spec, but the jack connected to the
`
J
external cable is not. You are recommended to install this product below the edge of eaves to
prevent the cable from being externally exposed.
precautions before installation
Ensure you read out the following instructions before installing the camera:
• It must be installed on the area (ceiling or wall) that can withstand 5 times the weight
of the camera including the installation bracket.
• Stuck-in or peeled-off cables can cause damage to the product or a fire.
• For safety purposes, keep anyone else away from the installation site.
And put aside personal belongings from the site, just in case.
installation
1. Attach the installation template to the
selected area and punch 3 holes as shown in
the figure.
2. Fix the camera in 3 holes by tightening the
three tapping screws supplied with the
product.
3. Connect the cables with the camera port.
4. Adjust the direction of the camera with a
Philips screwdriver. (SNO-L6013R)
5. Adjust the direction of the camera with the
L-wrench supplied with the product. (SNO-
L6083R)
Loosen the bracket screws, adjust the camera's
`
J
position and tighten the screws when you adjust the position of the camera by using a bracket.
If you adjust the camera's position by force when the screws are tightened, the camera may be
scratched or out of order.
34_ installation & connection
Hide quick links:
Advertisement
Table of Contents
