Samsung SND-L6013 User Manual page 115

3. Click the [test] button to see if you can successfully connect to the NAS.
If the success message is displayed, it means that you can successfully save data in the NAS.
J `
If the fail message is displayed, check the following.
`
-
Confirm that the IP address of the NAS is valid.
-
Confirm that the ID/password of the NAS is valid.
-
Confirm that you can access the folder designated as the default folder using the ID of the
NAS.
-
Confirm that the NAS SMB/CIFS items are unchecked.
-
Confirm that the NAS IP address and the camera IP address are in the same format.
ex) The NAS & camera subnet mask initial value is 255.255.255.0.
If the IP address is 192.168.20.32 then the NAS IP address should be in the range of
192.168.20.1~192.168.20.255.
-
Check whether you tried to access as another user without formatting the default folder saved
or used.
-
Confirm that you used recommended NAS equipment.
4. After the settings are completed, set the NAS unit to <on>.
5. Click the [apply (
6. Log in the NAS and check the <free size> and <total size>.
You can format the default folder specified in the NAS connection setting by clicking
the <format> button.
Since data may not be saved after a temporary network interruption when using NAS, it is
`
recommended that you use SD at the same time to prevent loss of recorded images.
The data traffic will increase when the camera is set to higher resolution, higher bit rate, and/or higher
`
framerate.
If there is too much data traffic, some frame may be skipped although it is stored in a full frame.
When a frame skip occurs, images are saved at the rate of min. one image per sec.
`
)] button.
English _115