Appliance Installation - Unox SpidoCook Instruction Manual

Appliance installation

Preliminary and positioning procedures
Installation site
Before positioning the appliance, check the measurements and the exact position of the electrical connections,
in accordance with the figures provided in the enclosed "Technical Data" booklet.
Caution!
Do not install the appliance near flammable materials. If the appliance is positioned near walls, partitions,
kitchen cabinets, decorative trim, etc., these items must be made from non-flammable material. If this is not
the case, they must be coated with a non-flammable heat insulating material, and all fire prevention regulations
must be strictly observed.
Removing the protective film
Carefully remove the protective film from the outer surfaces of the appliance, so that no glue residue is left
behind. Any remaining residue can be removed using a suitable solvent product.
Drip tray
The supplied fat collection drawer to collect the liquid waste that is deposited on glass ceramic surfaces.
The rounded drainage channel for the liquids, flowing all around the hobs, can easily convey liquids and dirt
into the removable drawer to further facilitate the clearing. Before to use for the fist time the grill insert the
supplied fat collection drawer in the in the front seat as shown in the 'image below.
Positioning
Warning
Position the appliance so that the back panel is easily accessible when performing electrical connection and
carrying out maintenance work. The appliance is not suitable for recessed installation, or for use as part of a
series of appliances. A minimum gap of 50 mm must be left around the entire perimeter of the appliance.If any
fryers or other potential sources of hot liquid spills are used in the kitchen, they should be placed at least 45
cm away from the sides and 70 cm away from the back of the appliance.
English
12