Warning Messages; Alarm Messages; Maintenance In The Event Of A Malfunction - Unox SpidoCook Instruction Manual

Oven-user communication
The digital control panel SpidoTouch used in SpidoCook™ digital grills is designed to alert the user to possible
error messages or failure.
If there is any warning or allarms push the button

Warning messages:

When a malfunction is detected which allows the appliance to continue operating, abeit in a limited manner,
a WARNING message is displayed. The device continues to run and the WARNING message remains on
the display until any operation button is pressed.
From the normal view, to verify the presence of any warning, hold for 5 seconds the buttons
simultaneously. It is possible to make this operation just if the grill is not working.
DISPLAY
MESSAGE
The temperature of the appliance
W01
power P .C.B. is too high
The temperature of the appliance
W02
control board is too high
W10
Basic control board setting error
Allarm messages:
When a condition arises which prevents the appliance from operating at all, an ALARM signal is displayed and the
appliance must be switched to its STOP status. The device stops operating and the ALARM! message appears
on the oven display until the problem is resolved. If the device is operating when the ALARM status occurs, it
will shut down and the alert corresponding to the detected problem will be displayed. To resolve a problem of
this type, contact an Authorised Assistance Centre. Once the problem has been resolved, the appliance can be
reactivated by pressing the «START» button.
DISPLAY
MESSAGE
A01
Temperature probe alarm
The safety thermostat has overheated
A02
(intervenes if the temperature rises
too quickly or when it reaches 370 ° C
Maintenance in case of failure:
In case of failure, in case of failure, failure of the ceramic surface or in case of occurrence of cracks,
immediately disconnect the unit from the mains and call a service center for replacement of glass.
English
to slide them.
Description
The appliance continues to operate
but there is a risk of permanent
damage to the power P .C.B.
The appliance continues to operate
but there is a risk of permanent
damage to the control board
The appliance keeps on working
(with some limitations due to the
setting involved on the error)
Description
Appliance shutdown
Appliance shutdown
10
Effect Problem solution
Contact the Customer Assistance
Service
Contact the Customer Assistance
Service
Contact the Customer Assistance
Service
Effect Problem solution
Contact the Customer Assistance
Service
Contact the Customer Assistance
Service
and