Generator Assembly And Mounting - PowerLand PD10000E Owner's Manual

GENERATOR ASSEMBLY AND MOUNTING

Generator is supplied with a wheel kit. If you want to install the wheel kit on your unit,
please follow the instructions below. If you not use the wheel kit, skip this section.
1. Place the bottom of the generator cradle on a flat, even surface. Temporarily place
unit on blocks to ease assembly.
2. Fix the support leg to the cradle with cap screws (M8 x 16) and tighten nuts (M8) (see
figure 22 ).
3. Put axle through both mounting braces on the cradle frame as shown，and then put
the lining through the axle (see figure 23、see figure 24).
4. Slide a wheel (with the inflation valve facing out) and a flat washer over the axle, then
tighten the wheel with nuts (M12) (see figure25、Figure 26).
5. Place the handles on the cradle tightly with plastic flat washer, cap screws(M8 X 16)
and tighten nuts(M8)( Figure 27、Figure 28).
6. Make sure that all fasteners are tight and tires are inflated between 15-40 PSI.
Figure 22
Figure 25
Figure 28
Figure 23
Figure 26
21
Figure 24
Figure 27