Aaeon SBC-780 User Manual page 77

F u l l-S i z e C P U C a r d
Programming
An onboard watchdog timer reduces the chance of disruptions which
CPLD (Compact Programmable Logical Device) interface can cause. This
is an invaluable protective device for standalone or punmanned
applications. When the watchdog timer activates (CPU processing has
come to a halt), it can reset the system, or generate an interrupt on IRQ10,
IRQ11, IRQ15, and NM1. This can be set via I/O Port 444, the function
as following:
0: RESET
1: NM1
2: IRQ10
3: IRQ11
4: IRQ15
If you decide to program the watchdog timer, you must write data to I/O
port 443 (hex). The output data is a value timer. You can write form 01
(hex) to FF (hex) while simultaneously setting it. When you want to disable
the watchdog timer, your program should read a Hex value from I/O port
80 (hex).
The following procesude is a sample program for the watchdog timer:
n
n
n
n
The time interval data of the watchdog timer is shown in binary code (8
bits).
Sample 2: 5 seconds
Appendix A Programming the Watchdog Timer
Type C:\DOS\Debug <ENTER>
To start watchdog timer and set function "Reset" type;
o 444 0<Enter>; out 444h data 0
To input Watchdog timers time-out interval of 5 seconds type;
o 443 05<Enter>; out 443h data 05
To disable the watch timer type; i80 <Enter>
0 0 0 0
S B C - 7 8 0
0 1 0 1
A-2