Resetting Your Heos Device - Denon HEOS Drive Owner's Manual

Contents

Resetting Your HEOS Device

Resetting your HEOS device will clear out EQ, and name but retain it's current software. You will have to use Settings->Add
Device to reconnect the device to your home network before it can be used. To reset your HEOS Drive, press the Reset button on
the back and hold it in until the Zone LED begins to flash amber.
Restoring the HEOS Device to Factory Defaults
Restoring the HEOS device to its factory defaults will clear all of the settings and restore the original software which was installed
at the factory.
Caution
All settings will be erased and the software will likely be downgraded!
To restore your HEOS Drive to the factory defaults, turn off the power switch of rear panel. Press the Reset button on the back,
turn on the power switch of rear panel, and hold it in until the Zone LED begins to flash amber.
* For further information, please visit HEOSbyDenon.com
Setup Use
Solution
Solution
Troubleshooting
49
Status LED Appendix
Refer to Page
Refer to Page
–
–