Adjusting The Output Mode - Denon HEOS Drive Owner's Manual

Contents

Adjusting the Output Mode

1
Select "Output Mode".
2
Select Stereo or Dual Mono.
Adjusting the Audio Quality
Selects the transcoding option for rebroadcasting audio from one HEOS
device to another HEOS device (or group of devices) across the network.
When set to "Normal", high bit rate audio sources originating from the first
device (such as AUX input, WAV, FLAC and PCM) will be transcoded to
ensure the highest level of reliability for the audio stream.
1
Select "Quality".
2
Select Normal (default) or High.
If you have selected High and you experience audio dropouts when streaming
sources from one device to other devices, please select Normal (default).
Setup Use Troubleshooting
Adjusting the Volume Limit
You can set the maximum volume of the HEOS Drive amplifiers to prevent
sudden loud volume.
1
Select "Volume Limit".
2
Select the maximum volume percentage (95, 90, 85,
80).
Adjusting the Preamp Out
ZONE2 and ZONE 4 "Volume limit" will change to "Preamp Out", when you
set the Bridge switch to "ON".
1
Select "Preamp Out".
2
Select Disabled or Enabled.
Disabled PRE OUT is disabled and does not appeared
(Default): in Rooms view.
PRE OUT is enabled and Zone Name
Enabled:
appeared in Rooms view.
39
Status LED Appendix