External Device Control - Denon HEOS Drive Owner's Manual

Contents

External Device Control

The HEOS Drive can tightly integrate with most Denon AVR to allow them
to operate as if they were one device.
You can configure your HEOS Drive to tell the connected device when to
turn on, turn off, select the correct input and adjust volume and mute.
You can adjust specific settings for each of your HEOS Drive in your
system:
1
Select the Settings a icon located in the upper left
corner of the main Music menu to display the Settings
menu.
2
Select "My Devices" to display a list of your devices.
3
Select a HEOS Drive.
4
Select the Zone you want to set.
5
Select "Control".
6
Select the method which is most appropriate for your
configuration:
Setup Use Troubleshooting
o IP Control
IP Control is available for Denon AV receiver models sold after 2010
which are connected to the same network as the HEOS Drive and
Controller devices.
1
Select IP.
2
Select the AVR that you have your HEOS Drive is
connected to.
3
Select the input on the AVR that you have your HEOS
Drive connected to.
4
Select Done.
NOTE
0 You can test the connection to the AVR by pressing the power on, off, and input
buttons.
0 The following settings are forced to change when IP Control is set.
0 Line Out Level: Fixed
0 High Pass Filter: Off
0 Subwoofer: Off
42
Status LED Appendix