Operating Instructions - Listen Technologies Stationary LA-350 Design Manual

LR-42/44 Operating Instructions
have been enabled/disabled, with the factory default settings highlighted. See page 102 for detailed
information about programming and operating units using non-default settings.
1
Connect an Earphone or Headset (LR-44 Model Only)
An earphone or headset will connect to the jack on the bottom of the unit. Either mono or stereo
connectors may be used with Listen receivers. Make sure to push the connector all the way into the jack.
2
Position the Unit on User's Body
ATTENTION: If desired, this step can be done after turning the unit on and selecting a channel as long as
the front of the receiver is not obstructed during the channel selection process.
IMPORTANT: Always wear the receiver in such a way that there is nothing covering the front lens of the
receiver. If the front lens is covered or obstructed the receiver will have very poor range.
1
2 3
4
1
95