Table of Contents
Advertisement
C. Motion：(Figure 5-25).
Motion Enable：To check it to enable the motion detection function.
Local (Software) or IP camera's Motion Detection：You may select the motion
detection event source from Camera or SmartVIEW to operate that.
Event Interval Time：If several events occurred within
of the events will be treated as a single event. This default value is 10 seconds
and can be set between 0 ～ 3600 seconds.
Sensitive：This setting defines the sensitivity of the motion detection. This
default value is 80 and the value can be set between 1～100. The higher value
means the higher sensitivity.
Add Action Zone：Click this button to create a zone for motion detection.
Select Whole Zone：Click this button to set the whole area on the video
become detection zone.
Delete Action Zone：Click this button to specify a zone which is disabled for
motion detection.
Delete All Zone：Click this button to disable all motion detection zones in the
picture.
Motion detection schedule：To set when to enable/disable the motion
detection according to weekday/hours or calendar date. (Refer to Figure 5-26)
：
Notice
One channel can only have one detection zone; therefore no matter
how many zones are drawn in a channel, they will all be regarded as one
irregular-shaped zone.
Figure 5-25
68
Event Interval
Time, all
Advertisement
Table of Contents
