Table of Contents
Advertisement
(2)
The following steps will guide you to set the automatic cruise of the speed dome or
cameras with a PT head：
A. Enable the PTZ control functions for a PTZ camera：
(A) Open the Configurations page.
(B) Select a specific Speed Dome Camera item in the IP Camera tree list.
：
Notice
The speed dome camera will be listed under the node, "IP Camera",
(Figure 4-12).
(C) Switch tab to General, and check the
(D) Users will also need to set the following setting for an "IP Camera"：
"Protocol", "Baud Rate", "Address ID", and "Home Position" (Figure 4-12).
B. Setup the preset point (Figure 4-13)
(A) Click the PTZ icon which is located at the Live View page (Figure 4-13,
(B) Adjust the PTZ angle of the cameras to focus at a specific range which you
want to monitor. (Figure 4-13)
(C) Click on the Set button and a dialog box which is named "PRESET" will be
pop-up. (Figure 4-13,
(D) Select the "Preset" No. and input an appropriate description for the specific
"Preset Position". Click the button Set Preset to setup a preset position or
click column "Descriptions" for updating descriptions for this preset point.
(Figure 4-13,
(E) Click the button OK to complete the setting. (Figure 4-13,
PTZ
Figure 4-12
)
)
43
Enable.
)
).
Advertisement
Table of Contents
