Motion Detection - Konig SEC-DVR504 Full Manual

HDD LOSS: When the "ON" setting has been selected for HDD Loss, the relevant alarm will
be triggered if there is no HDD connected to the DVR and a "
lower left corner of channel 1 while in live view mode.
VIDEO LOSS: When "ON" setting has been selected for Video Loss, the relevant alarm will
be triggered when one or more channels lose video input.
Note: If the buzzer mentioned in Section
triggered by any kind of activity.

5.6.5 Motion Detection

To access the "Motion Detection" menu, in the
toolbar, first click "System Settings," then click
Alarm." Next, select "Motion" and click ">>,"
and the dialog window where Sensitivity, MD
Detection, Output, Record, Buzzer, Prerecord,
and email settings can be set will appear.
CHANNEL: In this field, select the channel to be
set up.
SWITCH: Each channel has a corresponding channel switch; press "Enter" to turn the motion
detection for each channel on or off.
SENSITIVITY: Each channel has a specific sensitivity setting; there are eight levels, with "1"
being the highest level of sensitivity; press "Enter" to adjust the level.
MD AREA: Sometimes, it is necessary to have some regions in the camera's coverage area
enabled with the motion detection feature, while other regions in the same coverage area do not
require this functionality. This may be handy when, for example, the camera covers the road
and an adjoining area. While it would be useful to have the motion detection enabled on the
area near the entrance to a building, it would most likely not be helpful to see it triggered every
time a car or truck passes by on the nearby road. Each channel has a specific regional motion
detecting setting.
To enter the "Regional Setting" menu, move the cursor
to "setting" and then press "Enter." When viewing the
selected channel's coverage area using the MD Area
option, the blue area is where motion detection is
activated, and transparent block is the area where
motion detection is not activated.
Press the direction keys on the remote control to move
the cursor along the small pane: the position of cursor is
indicated by a green frame. Press "Enter" to select or
cancel motion detection in this small pane. When the
setup is finished, press"
to save the settings.
5.6.2 is in the "OFF" setting, they will not be
"or right click to return to the MD setup menu and click "
40
" icon will be displayed in the
"