Honeywell LYNX Touch User Manual page 20

SECURING THE PREMISES
Arming the System
Arming In Away Mode
Use this mode when no one will be staying on the premises. Close all protected perimeter
windows and doors before arming. The green READY indicator on the control should be lit if
the system is ready to be armed. When armed in AWAY mode, the system will sound an
alarm if a protected door or window is opened, or if any movement is detected inside the
premises, when infrared detection devices are used. You may leave through a designated
entrance door during the exit delay period without causing an alarm. You may also re-enter
through the entrance door, but you must disarm the system within the entry delay period or
an alarm will occur. If Quick Arm was programmed by the installer, you do not need to enter
the security code to arm the system. The security code must always be used to disarm the
system, however.
The Babysitter Code and Installer Code cannot disarm the system unless it was used to arm
the system. In addition, if the system is armed by pressing via Quick-Arming, neither the
Babysitter Code nor Installer Code can disarm the system.
Ready To Arm
Arm Away Arm Stay
10:18 AM June 8, 2010
Ready To Arm
Arm the system in Away mode
Enter Code:
Cancel
Zones
System
Message
More
5000-400-055-V1
1 2 3
4 5 6
7 8 9
Clear 0
5000-100-053-V0
– 20 –
1. Select the Arm Away icon, the system will
beep once and display a keypad.
2. Enter a valid User Code.
OR
If Quick Arm has been enabled, select the
"Quick Arm" icon.
The system will beep two times and
announce "Armed Away Exit Now. The exit
delay screen
programmed the display will count down the
time remaining in the exit delay in seconds.
Note: If a valid user code is not entered or the
Confirm icon has not been selected within 10
seconds, the system will return to the "home"
screen and it will not be armed.
will be displayed. If