Differential Fluid; Diesel Engine Manual Transmission - Cushman Turf Truckster
84043 Parts & Maintenance Manual

6 MAINTENANCE

6.22 DIFFERENTIAL FLUID______________________________________________________

The differential fluid should be checked every 100 hours
or 3 months. Fluid should be changed after the first 100
hours and every 600 hours (or yearly) thereafter.
Differential Fluid Capacity ...... 5.2 pints (2.5 l)
Level Check And
Fluid Type .............................. SAE EP 80-90 Gear Lube
Fill Plug
To check differential fluid level, remove the filler plug from
the front of the differential. Fluid should be level with the
bottom of filler hole.
If fluid is low, add gear lube until fluid begins to leak from
hole. Apply pipe thread sealant and install filler plug.
To change differential fluid, remove drain plug from rear
of differential.
Allow fluid to drain into a suitable container. Dispose of
Figure 6N
used fluid properly according to local and state
regulations.
Apply pipe thread sealer to drain plug and install.
Fill differential with gear lube until fluid begins to leak
from hole. Apply pipe thread sealant and install filler plug.
Drain Plug
Figure 6O

6.23 DIESEL ENGINE MANUAL TRANSMISSION ____________________________________

The transmission fluid should be checked every 100
hours or 3 months. Fluid should be changed every 600
hours (or yearly).
Level Check And
Differential Fluid Capacity ...... 1.35 qts (1.3 l)
Filler Plug
Fluid Type .............................. SAE EP 80-90 Gear Lube
To check transmission fluid level, remove the filler plug
Transmi ssi on
from the front of the transmission. Fluid should be level
Drain Plug
with the bottom of filler hole.
If fluid is low, add gear lube until fluid begins to leak from
hole. Apply pipe thread sealant and install filler plug.
To change fluid, remove drain plug from rear of
transmission.
Allow fluid to drain into a suitable container. Dispose of
Figure 6P
used fluid properly according to local and state
regulations.
Apply pipe thread sealer to drain plug and install.
Fill transmission with gear lube until fluid begins to leak
from hole. Apply pipe thread sealant and install filler plug.
GB-26