Maintenance; General; Engine - Cushman Turf Truckster
84043 Parts & Maintenance Manual

6

MAINTENANCE

6.1

GENERAL ________________________________________________________________

!
WARNING
Before you clean, adjust, or repair this equipment,
depress clutch pedal and shift transmission to neutral,
engage parking brake, stop engine and remove key from
ignition switch to prevent injuries
Make sure the vehicle is parked on a solid and level
surface. Never work on a vehicle that is supported only
by the jack. Always use jack stands.
1. Adjustment and maintenance should always be
performed by a
adjustments cannot be made, contact an Authorized
Jacobsen Dealer.
2. Inspect the equipment on a regular basis, establish a
maintenance schedule and keep detailed records.
6.2

ENGINE _________________________________________________________________

IMPORTANT: A separate Engine Manual, prepared by
the engine manufacturer, is supplied with this vehicle.
Read the engine manual carefully until you are familiar
with the operation and maintenance of the engine.
Proper attention to the engine manufacturer's directions
will assure maximum service life of the engine. To order
replacement engine manuals
manufacturer.
The proper break-in of a new engine can make a
considerable difference to the performance and life of the
engine.
Note: The vehicle is designed to operate most efficiently
at the preset governor setting. Do not change the engine
governor settings or overspeed the engine.
During the break-in period, Jacobsen recommends the
following:
1. During the first 50 hours of operation, a new engine
should be allowed to reach an operating temperature of
at least 140°F (60°C) prior to operation at full load.
2. Check the engine oil level twice daily during the first 50
hours of operation. Higher than normal oil consumption
is not uncommon during the initial break-in period.
3. Change engine oil and oil filter element after first 35
hours of operation.
4. Check and adjust hydraulic pump and alternator belts.
5. Refer to Section 8.3 and Engine Manual for specific
maintenance intervals.
qualified technician. If
contact the
a. Keep the equipment clean.
b. Keep all moving parts properly adjusted and lubri-
cated.
c. Replace worn or damaged parts before operating
the machine.
d. Keep all fluids at their proper levels.
e. Keep shields in place and all hardware securely
fastened.
f. Keep tires properly inflated.
3. Long hair, jewelry or loose fitting clothing may get
tangled in moving parts.
proper
4. Use the illustrations in the Parts Catalog as reference
for the disassembly and reassembly of components.
5. Recycle or dispose of all hazardous materials
(batteries, fuel, lubricants, anti-freeze, etc.) according
to local, state or federal regulations.
6. If the injection pump, injectors or the fuel system
require service, contact an authorized Jacobsen
Dealer.
Keep your engine clean. If dirt has accumulated on the
engine, it should be washed with a non-flammable
solvent or strong detergent.
engine
When washing becomes necessary, it can be carried out
simultaneously when servicing the vehicle.
In order to maintain reliable service from your engine, a
regular check-up and maintenance scedule should be
followed. Proper maintenance will prolong the engine's
life and avoid premature overhaul.
MAINTENANCE 6
GB-15