Air Filter; Jump Starting - Cushman Turf Truckster
84043 Parts & Maintenance Manual

6.8

AIR FILTER _______________________________________________________________

Do not remove the element for inspection or cleaning.
Unnecessary removal of the filter increases the risk of
injecting dust and other impurities into the engine.
When service is required, first clean the outside of the
filter housing; then remove the old element as gently as
possible and discard.
1. Carefully clean the inside of the filter housing without
allowing dust into the air intake.
2. Inspect the new element. Do not use a damaged
element and never use an incorrect element.
3. Assemble the new element and make sure it seats
properly.
4. Reassemble cap making sure it seals completely
around the filter housing. Dust evacuator (A) must be
facing down.
5. Check all hoses and air ducts. Tighten hose clamps.
6.9

JUMP STARTING __________________________________________________________

Before attempting to "jump start" the vehicle, check the
condition of the discharged battery.
Engage parking brake of both vehicles, shift transmission
to neutral and turn off all electrical loads
!
WARNING
Batteries generate explosive hydrogen gas. To reduce
the chance of an explosion, avoid creating sparks near
battery. Always connect the negative jumper cable to the
frame of the vehicle with the discharged battery, away
from the battery.
When connecting jumper cables:
1. Stop the engine on the vehicle with a good battery.
MAINTENANCE
Diesel
Engine
A
A
Gas Engine
2. Connect RED jumper cable to the positive (+) terminal
on the good battery and to the positive (+) terminal on
the "discharged" battery.
3. Connect the BLACK jumper cable from the negative
(-) terminal on the good battery to the frame of the
vehicle with the discharged battery.
After cables have been connected, start the engine on
the vehicle with the good battery then start the vehicle.
6
Figure 6D
GB-19