Identification Codes - Kenwood TK-7360 Instruction Manual

FleetSync: ALPHANUMERIC 2-WAY PAGING FUNCTION
FleetSync is an Alphanumeric 2-way Paging Function and is a protocol owned by
Kenwood Corporation.
Note: If set up by your dealer, your transceiver may use the MDC-200 feature in place of
FleetSync. MDC-200 and FleetSync cannot be operated simultaneously.
S (S
elcAll electiVe
A Selcall is a voice call to a particular station or to a group of stations.
n Transmitting
1 Select your desired zone and channel.
2 Press the key programmed as Selcall or Selcall + Status.
3 Press /
or <B/C> to select the ID of the station you want to call.
• You can also enter the station ID directly by using the keypad.
4 Press the PTT switch and begin your conversation.
• You can also press
n Receiving
If enabled by your dealer, an alert tone will sound and the LED will blink when
a Selcall has been received. To respond to the call, press the PTT switch and
speak into the microphone.
n Identification Codes
An ID code is a combination of a 3-digit Fleet number and a 4-digit ID number.
Each transceiver must have its own Fleet and ID number.
Note: The ID range may be limited by programming.
p c
Aging All
1 Select your desired zone and channel.
2 Press the key programmed as Paging Call to transmit your PTT List ID, to
request a call.
S m
tAtuS eSSAge
Status messages are 2-digit codes ranging from 0 to  (0 ~  are reserved
for special messages).
A maximum of 5 received messages can be stored in the stack memory of your
transceiver and can be reviewed after reception. The
message is stored in the stack memory.
c )
Alling
(if the key assignment list selection is configured as "Enabled")
to page the ID, rather than talking.
n
icon appears when a