Useful Advice - Black & Decker FC300 User Manual

ENGLISH
6. Place the chopper body on to the assembled
jug. Ensure that the spindle of the drive
blade goes into the drive shaft under the
chopper body.
Use
1. Place the appliance on a flat, stable surface.
2. Place the assembled blade into the jug.
3. Place the ingredients into the jug.
4. Place the jug lid onto the jug.
5. Place the chopper body on to the assembled
jug.
6. Connect it to the electricity supply.
7. Press down on the chopper body to start the
appliance.
The appliance should be
disconnected from the mains supply
before removing from the jug.
The appliance will not operate
without the jug lid fitted.
Do not operate the appliance without
the drive blade fitted.
6
Do not operate the appliance without
the secondary blade fitted.
The chopper should not be run for longer than
60 seconds. After a continuous run of 60
seconds, the chopper should be allowed to cool
for at least 5 minutes before further use.

Useful advice

•
Place the appliance on a clean, flat work
surface.
Note: Do not exceed the maximum capacity of
0.5 litres.
•
When chopping is complete disconnect the
appliance from the power socket.
•
Once the blades have come to a complete
stop, lift the chopper body from the jug.
Remove the lid and blades then pour the
ingredients into a suitable container.
•
After use the cable of the appliance can be
wrapped around the top of the chopper body
for storage.
Recommended run time
Run Time
Food
(Seconds)
Onion 10
Garlic 3
Ginger 3
Carrot 4
Meat 25
Ice cubes 37
Comments
240g cut into
quarters
150g whole
peeled cloves
150g cut into
thumb sized pieces
150g cut into
thumb sized pieces
350g cut into
2cm cubes
10 ice cubes