Table of Contents
Advertisement
Symbols on the machine and/or in
the manual:
WARNING! Chain saws can be
dangerous! Careless or improper use
can result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
•
Approved protective helmet
•
Approved hearing protection
•
Protective goggles or a visor
Both of the operator ' s hands must be
used to operate the chain saw.
Never operate a chain saw holding it with
one hand only.
Contact of the guide bar tip with any
object must be avoided.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches
an object, and cause a lightning fast
reverse reaction, kicking the guide bar
up and towards the operator. May cause
serious personal injury.
Chain brake, activated (left)
Chain brake, not activated (right)
Decompression valve: The valve is
to reduce the pressure in the cylinder and
make starting easier. You should always
use the decompression valve when
starting the machine.
Ignition; choke: Set the choke control
in the choke position. This should
automatically set the stop switch to the
start position.
Air purge
Adjustment of the oil pump
1153598-95 Rev.1 2010-08-25
KEY TO SYMBOLS
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
Switch off the engine before carrying out
any checks or maintenance.
Always wear approved protective gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be
worn.
Refuelling.
Filling with oil and adjusting oil flow.
The chain brake must be engaged when
the chain saw is started.
–
English
7
Advertisement
Table of Contents
