Error Messages; Speaker Shorted - Sony STR-DA5800ES Operating Instructions Manual

• To reset the lighting device, press the
button on the top of the lighting device 13
times. The LED will turn to red and then
back to green or emit an orange-yellow
strobe.
The lighting device cannot be
operated.
• The device may be updating its software.
Wait for about half an hour until the update
is completed.
• It may be off-line. Wait for half an hour
until the device returns online.
• Reset the lighting device and delete the
identified device on the receiver. Reboot
the receiver and then set up the Lighting
Control function again. Also perform the
procedures necessary to reset the lighting
device described above.
The Lighting Control function doesn't
work.
• The Lighting Control Adapter may have
been unplugged while the power was on
and the system data may be corrupted.
Reset the lighting device and delete the
identified devices on the receiver. Then
reboot the receiver and set up the Lighting
Control function again.
• Hold down ?/1 on the receiver until the
lamp above ?/1 flashes in green to reboot
the receiver.

Error messages

You can check the status of the receiver by the
message. See the following to solve the
problem. If any problem persists, consult your
nearest Sony dealer.
PROTECTOR
The receiver is covered and ventilation holes
are blocked. The receiver will automatically
turn off after a few seconds. Remove the
object covering the upper panel of the
receiver and turn on the power again.

SPEAKER SHORTED

Irregular current is output to the speakers
due to a short circuit on the speaker
terminals. The receiver will automatically
turn off after a few seconds. If the protective
device on the receiver is activated due to a
short-circuit problem, turn off the receiver.
Check the connection of the speakers and
turn on the power again.
FAN STOPPED
Check that the ventilation hole on the top of
the receiver is not blocked.
"A new software version is available.
Please go to the "Setup" section of the
menu and select "Network Update" to
perform the update." appears on the TV
screen.
See "Network Update" (page 122) to update
the receiver to a newer software version.
Video cannot be output from this jack.
• If you use the receiver in the main zone,
connect the receiver to a TV via an HDMI
cable.
• If you connect the receiver to a TV via a
video cord, set "Playback Resolution" to
"480i/576i" (page 113).
• If you connect the receiver to a TV via a
component video cord, set "Playback
Resolution" to a parameter appropriate to
your TV (page 113).
continued
141 US