Front Panel Controls - Pittsburgh Modular Patch Box Manual And Patch Manual

Front Panel Controls

SWITCH 1 - Patchable footswitch can be used as on/off or A/B switch.
SWITCH 2 - Patchable footswitch can be used as on/off or A/B switch.
BYPASS - True bypass circuit enables or disables the entire Patch Box.
GAIN Knob - Controls the gain of the 1/4" input jack. Signal begins to overdrive after 12 o'clock.
OUTPUT Knob - Controls the output level of the Patch Box.
INPUTS Jacks - Dual buffered jacks carry the preamp output signal. Patch into the signal input of
installed modules or the OUT jack.
EXP 1 Jack- Output of Expression pedal 1. Outputs a voltage between 0-5v used to control one or
more voltage controllable parameters of the installed modules.
EXP 2 Jack- Output of Expression pedal 2. Outputs a voltage between 0-5v used to control one or
more voltage controllable parameters of the installed modules.
MULTIPLE Jacks- Used to split an audio or control signal. Patch a signal in and use the remaining
two jacks as copies of the input signal.
SWITCH 1 Jacks- Used to patch through SWITCH 1. The center jack is always active so pressing
footswitch 1 switches between activating the left and center jacks (LED off) or the right and
center jacks (LED on).
SWITCH 2 Jacks- Used to patch through SWITCH 2. The center jack is always active so pressing
footswitch 2 switches between activating the left and center jacks (LED off) or the right and
center jacks (LED on).
OUT Jack- Passed audio from modules through the Output level control to the rear mounted 1/4"
output jack.
5