Table of Contents
Advertisement
Switchable Effects Chaining
This is a big patch with an important feature set. It utilizes both footswitches and the
multiple to allow for individual bypass control of two different effects modules. The patch
assigns one module to footswitch 1 and a second module to footswitch 2. This is a
complex patch but shows the power of a modular effects unit.
The logic of this patch is that the input signal is sent through one of four paths
determined by the two footswitches. Both effects modules bypassed. Effect module 1
active and effect module 2 bypassed. Effect module 1 bypassed and effect module 2
active. Both effects modules active.
The preamp input is sent to effect 1 (Filter) and the output of the filter is sent to the on
position (right jack) of Switch 1. The off position (left jack) of Switch 1 is patched to the
Patch Box input. The output of Switch 1 (center jack) is sent to a multiple so the signal can
be split and patched into both the Filter input and the Switch 2 off position (left jack). The
output of the Filter is patched to the on position (right jack) of Switch 2. The output of
Switch 2 is then patched to the Patch Box output jack.
18
Advertisement
Table of Contents
