Table of Contents
Advertisement
Default Patch (Preamp Overdrive)
The default Patch Box patch does not require any modules. Plug a guitar or other
instrument into the 1/4" input on the rear of the Patch Box enclosure. This will turn on
the unit. Next, plug the output of the Patch Box into an amplifier, mixer, or audio interface.
With the Patch bypass foot switch LED off, the Patch Box circuitry is bypassed. Press the
[BYPASS] button to turn on the red bypass LED and engage the Patch Box circuitry. Use
an 1/8" patch cable to patch between one of the [INPUTS] and output [OUT] jacks.
The [GAIN] knob offers a clean boost until the knob reaches around 12 o'clock. After 12
o'clock, the preamp begins to add a smooth overdrive. Once the [GAIN] is set, adjust the
[OUTPUT] knob to match levels with the bypassed signal by switching between the active
and bypassed sounds using the [BYPASS] button.
This patch does not utilize the expression pedal inputs or footswitches.
10
Advertisement
Table of Contents
