Installation; Installation Requirements; Unpacking; Location - Valdorf GT8600G Installation And Operation Manual

Installation

Installation Requirements

NOTE:
 It is most important that this appliance is installed correctly and that operation is correct
before use. Installation shall comply with local, gas, health and safety requirements.
 This appliance shall be installed with sufficient ventilation to prevent occurrence of
unacceptable concentrations of health harmful substances in the room, appliance is
installed in.
Waldorf Griddle Toasters are designed to provide years of satisfactory service and correct installation is
essential to achieve the best performance, efficiency and trouble-free operation.
This appliance must be installed in accordance with National installation codes and in addition, in
accordance with relevant National / Local codes covering gas and fire safety.
Australia / New Zealand:
United Kingdom:
Ireland:
Installations must be carried out by qualified service persons only.
equipment to relevant codes and manufacturers specifications shown in this section will void
the warranty.
Components having adjustments protected (e.g. paint sealed) by the manufacturer, are only
to be adjusted by a qualified service person. They are not to be adjusted by the installation
person.

Unpacking

 Remove all packaging and transit protection from appliance including all protective plastic coating
from exterior stainless steel panels.
 Check equipment and parts for damage. Report any damage immediately to carrier and distributor.
 Report any deficiencies to distributor who supplied appliance.
 Check available gas supply is correct to as shown on rating plate located on right hand inner side
panel.
 Check that the following parts have been supplied with appliance:
Enamelled Crumb Tray
Toasting Rack
Toasting Rack Tray (St/Steel)
Grease Drawer
Adjustable Legs
Gas Regulator
Alternate Gas Conversion Kit

Location

1. Installation must allow for a sufficient flow of fresh air for combustion air supply.
2. Installation must include adequate ventilation means, to prevent dangerous build up of combustion
Combustion Air Requirements:
Natural Gas (G20)
LPG (G31)
Town Gas
products.
3. Position appliance in its approximate working position.
4. All air for burner combustion is supplied from beneath appliance. Legs must always be fitted and no
obstructions placed beneath or around base of appliance, as obstructions will cause incorrect
operation and / or failure of appliance.
- AS/NZS5601 - Gas Installations.
- Gas Safety (Installation & Use) Regulations 1998.
- BS6173 - Installation of Catering Appliances.
- BS5440 - 1 & 2 Installation Flueing & Ventilation.
- IS 820 - Non Domestic Gas Installations.
1
1
1
1
4
1
1
3
10 m /hr
3
9 m /hr
3
10 m /hr
6
Failure to install