Gas Conversion And Specifications; Conversion Procedure - Valdorf GT8600G Installation And Operation Manual

Gas Conversion and Specifications

Conversion Procedure

Ensure Appliance is isolated from gas supply before commencing servicing.
NOTE:
 These conversions should only be carried out by qualified persons. All connections must
be checked for leaks before re-commissioning the appliance.
 Adjustment of components that have adjustments / settings sealed (e.g. paint sealed) can
only be adjusted in accordance with the following instructions and shall be re-sealed
before re-commissioning this appliance.
 For relevant gas specifications refer to
Main Burners
1. Remove the following:-
 Control Panel.
 Toasting Rack.
 Main Burner.
2. Remove injectors and replace with correct size injectors
as shown in 'Gas Specifications Tables' at rear of this
section.
3. Refit the following:-
 Main Burner.
 Toasting Rack.
Pilot Burners
1. Disconnect the following:-
 Pilot Supply and Thermocouple Tubes from Gas Control
Valve.
 Pilot Assembly from Griddle Toaster.
2. Remove pilot injectors and replace with correct size pilot
injectors as shown in 'Gas Specifications Tables' at rear of
this section.
3. Re-connect the following:-
 Pilot Supply and Thermocouple Tubes to Gas Control
Valve.
 Pilot Assembly to Griddle Toaster.
Low Fire Adjustment
1. Light main burners and check flame size on 'Low' position.
 Adjust low fire adjustment screw on burner gas control valves to
obtain desired flame size.
NOTE: 'Low Fire Adjustment Screw' should be sealed with coloured
paint on completion of low fire adjustment.
2. Refit control panel.
3. Refit gas control knobs to gas control valves.
Caution
'Gas Specifications Tables'
Main Burner Injector
16
at rear of this section.
Wing Nut
Thermocouple
Connection
Pilot Gas Supply Tube
Pilot Bracket
Securing Screws
Low Fire Screw