Passenger Station Announcements (Psa) - Rail King 4-6-4 Dreyfuss Locomotive Operator's Manual

Passenger Station Announcements (PSA)

Your engine is equipped with a sound package of passenger station announcements that
you can play when you pull into a station. Each sequence described below will play as
long as it is left on, randomly generating sounds, but be sure to allow approximately 30
seconds between the button pushes described below to allow the PSA sufficient time to
run through each sequence.
•
To cue the sound system to play the PSA, quickly but firmly tap the Bell button
once followed by 2 quick taps of the Horn button while the engine is moving.
Tap the buttons quickly but allow approximately ½ second between each press.
•
Press the Direction button once to stop the engine. This will trigger the first
sequence of PSA. The reverse unit is temporarily disabled so that the train will
not move as you use the Direction button to trigger the sounds, and Proto-Sound
2.0 has disabled operator control over the Horn and Bell buttons until the full
PSA sequence is complete.
•
After waiting about 30 seconds for that sequence to run, press the Direction
button again to trigger the second sequence of PSA.
•
After about 30 seconds, press the Direction button again to trigger the third PSA
sequence.
•
Again, after allowing about 30 seconds for that sequence to run, press the
Direction button one more time to trigger the fourth and final PSA sequence.
The PSA will continue, and within a few seconds, the engine and bell will start
and move out on its own at the current throttle setting, in the same direction it
was traveling when you began the sequence. Once the bell turns off, the operator
Horn
Bell
Sound System Cued
to Play Passenger
Station Announcements (PSA)
8
+
Direction
Horn
1st
Sequence
PSA
RailKing Dreyfuss Steam Engine
+ +
Direction Direction
2nd
Sequence Sequence
PSA
+
Direction
3rd 4th
Sequence
PSA PSA
Operator
=
Controls
When Bell
Turns Off