Ford 2010 Navigator Owner's Manual page 529

POWER TILT STEERING
The steering column can be
adjusted manually by moving the
two-way rocker adjustment control
located below the turn signal/wiper
control stalk. Hold the control to
adjust.
The tilt function is adjusted by
depressing the control up or down.
Easy entry/exit feature
When you remove the key from the ignition, the column will move to the
full up position if this feature is activated through the message center.
Refer to Message center in the Instrument Cluster chapter. When the
key is inserted into the ignition, the column will return to the previous
setting.
Note: The easy entry/exit feature will prevent the steering wheel from
returning to the memory position until the key is inserted into the
ignition.
Memory feature
The steering column positions are saved when doing a memory set
function and can be recalled along with the vehicle personality features
when a memory position is selected through the remote entry
transmitter, keyless entry keypad or memory switch on the side of the
driver's seat (if equipped with memory feature). Refer to Seating in the
Seating and Safety Restraints chapter.
If the steering column adjustment control is pressed during memory
recall it will cancel the automatic operation and the column will respond
to manual adjustment of the control.
WARNING: Never adjust the steering column when the vehicle
is moving.
2010 Navigator (nav)
Owners Guide (own2002), 1st Printing
USA (fus)
Driver Controls
99