Table of Contents
Advertisement
Appendix F: Configure Port Forwarding Manually
Important: Some ISPs block access to port 80. Be sure to check with your ISP so that you
can open the appropriate ports accordingly. If your ISP does not pass traffic on port 80, you
will need to change the port the camera uses from 80 to something else, such as 8080. Not
all routers are the same, so refer to your user manual for specific instructions on how to open
ports.
Enter valid ports in the Virtual Server section of your router. Please make sure to check the
box on this line to enable settings. Then the device can be access from WAN by the router's
WAN IP Address.
By now, you have finished your entire PC configuration for this device
80
Advertisement
Table of Contents
