Calypso CA-500 User Manual page 10

2. Set Start Ch assign the current channel as the default channel used upon system start
up.
3. Vol + / Vol - increase and decrease output volume through 32 steps.
4. Set Start Vol assign the current volume setting as the default volume used upon system
start up. Warning: This allows full power start.
5. Mute Off - toggle mute on and off
6. Bal R > / Bal L < - balance left and right outputs through 16 steps (8 on each side).
1.3.3 Other Settings
unit is scanning for CIRT1 IR codes, CIRT2 IR codes, or Both CIRT1 and CIRT2 codes.
A complete description of CIRT codes is provided in section 2.0 of this manual, which
covers IR control.
st
2. IR Trg: 1 code toggle the IR receiver to process the 1
from a single IR remote control burst .
3. IR Help shows CIRT1 and CIRT2 IR codes (hex) and their corresponding CA
commands.
4. POT Settings assists with remote diagnostics and troubleshooting
5. Serial Port define serial port communications settings
6. Tone Off toggle to turn a 900Hz test tone on and off. The goal is to provide an output
signal for testing speaker connections.
7. CIRT 2 Settings assign a specific 4-char CIRT (Calypso IR Trigger) code to specific CA
Series functions. Use the pulldown menu to select a specific function, type in a 4-char
CIRT code and click the Assign button to associate the function with the code. Refer to
section 2.1 of this manual for detailed information on CIRT codes.
CA-Config includes a
number of additional
variable settings.
1. Both Codes
toggle
whether
st nd rd
, 2 or 3 IR code, transmitted
button
selects
the
Page 10