Gigabit ExpressCard Adapter
3. The driver files will be copied onto your PC.
4. This screen will appear when the installation is complete. Click Finish to finish the installation.
Click the Exit tab to exit the Utility.
Hardware Installation
1. Make sure that your Notebook PC is turned off.
2. Locate your PC's ExpressCard slot (usually located on the side). Insert the pin end of the Adapter into the slot
with the LEDs facing up. Make sure that the Adapter seats firmly in place.
3. Connect an Ethernet cable to the Ethernet port on the Adapter, then connect the other end to the Ethernet port
on the switch or other networking device.
The setup and installation are complete.
Chapter 2: Setup and Installation of the Gigabit ExpressCard Adapter
Hardware Installation
The setup is complete.
Figure 2-5: Setup Being Performed
Figure 2-6: Installation Complete
4