Table of Contents
Advertisement
6. At this point, you may see a warn-
ing screen, such as that shown in
Figure 4-6 , asking if you'd like to
cease installation. You can click
the Yes button to continue; the
Adapter will function properly.
7. After the files have been successfully copied, the screen in Figure 4-7 will
appear. Click the Exit button.
Proceed to "Chapter 5: Hardware Installation."
8
Figure 4-6
Figure 4-7
Chapter 5: Hardware Installation
Important for Windows 2000 users: You must run the Setup Wizard
to install the software before installing the hardware.
Important for Windows XP users: You must install the Adapter's
hardware before installing the software.
Connecting the Adapter
1. The Adapter comes with the USB cable you will use to connect the Adapter
to your PC. (See Figure 5-1.)
Wireless-G USB
Network Adapter
Figure 5-1
2. Connect one end of the USB cable to the USB port of the Adapter.
3. Connect the other end of the USB cable to one of the USB
ports on your computer (see Figure 5-2).
Figure 5-2
9
Advertisement
Table of Contents
