Maintenance; Recommended Maintenance Schedule - Toro Z355 Z-Master Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule

Maintenance Service
Interval
After first use
Each use
Every 8 hours
Every 25 hours
Every 40 hours
Every 100 hours
Every 200 hours
Every 600 hours
Before storage
1
More often in dusty, dirty conditions
Important Refer to your engine operator's manual for additional maintenance procedures.
Maintenance Procedure
• Check the hydraulic fluid level.
• Change the oil.
• Change the hydraulic filter.
• Check the oil level.
• Check the safety system.
• Clean the hopper.
• Clean the mower housing.
• Check the cutting blades.
• Check the hydraulic fluid level.
• Check the filter gage, replace filter when indicated and reset gage.
1
• Grease the chassis.
1
• Grease the drive shaft.
• Grease the push arm bearings.
1
• Grease the PTO idler.
• Grease the castor wheels.
• Clean the cooling systems.
• Check tire and castor tire pressures.
• Check the belts for wear/cracks.
• Grease the motion control lever pivot.
• Check the mower gearbox oil.
• Change the engine oil.
• Check the primary air cleaner.
• Check the hydraulic lines.
• Change the mower gearbox oil (initial).
• Change the oil filter.
• Change the hydraulic filter.
• Check the spark plug(s).
• Replace the fuel filter.
• Replace the safety air cleaner.
• Perform all maintenance procedures listed above before storage
• Drain the gasoline.
• Charge the battery and disconnect the cables.
• Check the battery electrolyte.
• Paint chipped surfaces.
30
1
1
1
1