Samsung AM7500 User Manual page 17

Wait until the LED indicator on the speaker stops flashing. If the speaker's LED indicator
4
turns solid blue, pairing is complete. The speaker may also beep.
NOTES
9 Place each speaker at least 20 inches (50 cm) from the HUB when connecting them to the HUB.
9 Your smart device cannot connect to the WAM speakers or the HUB if there is no wireless router.
9 To confirm you have a proper connection, check the pairing indicator on the front of the HUB.
- When you turn on the HUB for the first time, there is a 20 minute pairing period.
The pairing indicator (
SPK ADD
the
pairing indicator (
want to pair with the HUB while the pairing indicator is flashing.
- If pairing mode is turned off, start pairing mode again by pressing the
side of HUB and restart the speaker, or press and hold both
the same time for more than 5 seconds.
9 For a proper connection, connect the HUB to your router before turning on your WAM speaker.
- Connecting the speaker to the HUB may take a few minutes.
- There will be a brief sound when the connection is established.
Connect your smart device to your Wi-Fi network. (The HUB and the smart device should
5
be connected to the same router.)
) will blink for these 20 minutes or until pairing occurs. When you press
button to pair additional speakers, the pairing period is reduced to 10 minutes. The
) flashes for 10 minutes or until pairing occurs. Turn on the WAM speaker you
Source
44 17
SPK ADD
button on the rear
Standby
and buttons at