Maintenance; Sanding Operation - Makita BO4555 Instruction Manual

Finishing sander
Hide thumbs Also See for BO4555:
Table of Contents

Advertisement

009095
Make sure that the logo on the cardboard lip and the logo
on the dust nozzle are on the same side, then install the
dust nozzle on the dust box.
Removing dust box and paper filter bag.
2
1
009092
Remove the dust nozzle by pushing the two latches.
009093
Remove the paper filter bag first by pinching the logo
side of its cardboard lip, then by pulling the cardboard lip
downwards to move it out of the holding tab of the dust
box.
OPERATION

Sanding operation

008294
CAUTION:
Never run the tool without the abrasive paper. You
may seriously damage the pad.
1. Dust box
2. Dust nozzle
1
2
1. Latch
2. Dust nozzle
Never force the tool. Excessive pressure may
decrease the sanding efficiency, damage the
abrasive paper and/or shorten tool life.
Hold the tool firmly. Turn the tool on and wait until it
attains full speed. Then gently place the tool on the
workpiece surface. A finishing sander is generally used
to remove only a small amount of material at a time.
Since the quality of the surface is more important than
the amount of stock removed, do not bear down on the
tool. Keep the base flush with the workpiece at all times.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may
result.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
ACCESSORIES
CAUTION:
These
accessories
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Abrasive paper (without pre-punched holes)
Paper dust bag
Paper dust bag holder
Punch plate
Dust bag
Dust box
Paper filter bag
7
or
attachments
Only use
accessory or
are

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bo4556Bo4557Bo4558

Table of Contents