Table of Contents
Advertisement
the holes on the pad (the dust will be sucked into
these holes; it is therefore important to leave them
open).
3.
Press the paper firmly over the pad.
To remove the sandpaper:
1.
Set the tool upside down so that the sandpaper is
on top.
2.
Grasping one corner of the sandpaper, peel it from
the pad.
NOTE:
If the sandpaper is in good condition, save it for
•
further use.
Dust bag (accessory)
008301
The use of the dust bag makes sanding operations clean
and dust collection easy. To attach the dust bag, fit the
bag's entry port onto the dust spout on the tool. Make
sure that the hole in the bag's entry port is just over the
pimple-like protrusion on the dust spout.
For the best results, empty the dust bag when it becomes
approximately half full, tapping it lightly to remove as
much dust as possible.
Installing paper dust bag (accessory)
2
1
3
003742
Place the paper dust bag on the paper dust bag holder
with its front side upward. Insert the front fixing cardboard
of the paper dust bag into the groove of the paper dust
bag holder.
1. Dust bag
1
1. Groove
2. Front fixing
cardboard
3. Front side of
paper dust bag
1
003743
Then press the upper part of the front fixing cardboard in
arrow direction to hook it onto the claws.
1
003744
003745
Insert the notch of the paper dust bag into the guide of
the paper dust bag holder. Then install the paper dust
bag holder set on the tool.
Installing paper filter bag
009094
Make sure that the logo on the cardboard lip and the logo
on the dust box are on the same side, then install the
paper filter bag by fitting the cardbord lip in the groove of
each holding tab.
6
1. Claws
2. Upper part
2
1. Notch
2. Guide
2
1. Holding tab
1
Advertisement
Table of Contents
