Converting To Side Discharge (For Models With 127 Cm (50-Inch) Decks) - Toro TimeCutter SW 4200 Operator's Manual

1. Discharge cover
2. Cap nut (1/4 inch)
6. Secure the discharge cover to the lower lip of the
mower with 2 bolts (1/4 x 2-1/2 inches) and 2 cap nuts
(1/4 inch) as shown in
Note: Do not overtighten the nuts; this could distort
the cover and cause blade contact.
Converting to Side Discharge
(for models with 127 cm
(50-inch) decks)
The mower deck and mower blades shipped with this machine
were designed for optimum mulching and side discharge
performance.
Removing the Right Baffle for Side
Discharge
1. Park the machine on a level surface and disengage the
blade-control switch.
2. Ensure the parking brake is engaged, stop the engine,
remove the key, and wait for all moving parts to stop
before leaving the operating position.
3. Remove the right mower blade; refer to
Blades (page 44).
Figure 22
3. Bolt (1/4 x 2-1/2 inches)
Figure 22.
Removing the
4. Remove the 2 knobs and curved washers that secure
the right baffle to the mower
1. Knob
2. Curved washer
5. Remove the right baffle and lower the grass deflector
over the discharge opening as shown in
Figure 24.
1. Right baffle
2. Curved washer and knob
6. Install fasteners into the holes in the top of the mower
to prevent flying debris.
27
(Figure 23).
Figure 23
3. Baffle stud coming through
the mower
Figure 23
Figure 24
3. Discharge opening
and