Cleaning; Cleaning Under The Front Of The Machine; Washing The Underside Of The Mower - Toro TimeCutter SW 4200 Operator's Manual

Cleaning

Cleaning Under the Front of
the Machine
Service Interval: After each use—Check and clean the front
of the machine.
Remove debris under the front of the machine with
compressed air or by hand with a brush
Note: Do not use water to clean under the front of the
machine, this can cause build up of debris.
Figure 68
Washing the Underside of the
Mower
Service Interval: After each use—Clean the mower-deck
housing.
Important: You can wash the machine with a mild
detergent and water. Do not pressure wash the machine.
Avoid excessive use of water, especially near the control
panel, under the seat, around the engine, hydraulic
pumps, and motors.
Wash the underside of the mower after each use to prevent
grass buildup for improved mulch action and clipping
dispersal.
1. Park the machine on a level surface and disengage the
blade-control switch.
2. Ensure the parking brake is engaged, stop the engine,
remove the key, and wait for all moving parts to stop
before leaving the operating position.
3. Attach the hose coupling to the end of the mower
washout fitting, and turn the water on high
Note: Spread petroleum jelly on the washout fitting
O-ring to make the coupling slide on easier and protect
the O-ring.
(Figure 68).
(Figure 69).
51
Figure 69
1. Washout fitting
2. Hose
4. Lower the mower to the lowest height-of-cut.
5. Sit on the seat and start the engine.
6. Engage the blade-control switch and let the mower run
for 1 to 3 minutes.
7. Disengage the blade-control switch, stop the engine,
remove the ignition key, and wait for all moving parts
to stop.
8. Turn the water off and remove the coupling from the
washout fitting.
Note: If the mower is not clean after one washing,
soak it and let it stand for 30 minutes. Then, repeat
the process.
9. Run the mower again for 1 to 3 minutes to remove
excess water.
WARNING
A broken or missing washout fitting could
expose you and others to thrown objects or
blade contact. Contact with blade or thrown
debris can cause injury or death.
• Replace broken or missing washout fitting
immediately, before using mower again.
• Never put your hands or feet under the
mower or through openings in the mower.
3. O-ring
4. Coupling