Parts Provided - GE ZVC30LSS Installation Instructions Manual

PARTS PROVIDED

Locate the parts packed with the hood.
CHECK INSTALLATION HARDWARE
Count screws/
components. Screws
shown actual size.
6 wood
screws for
hood liner
8 wood
screws for
insert
sleeve
2 wing nuts
with lock
washers for
blower motor
REMOTE MOUNTING OF THE CONTROL (WIRED)
Blanking plate for
remote control
opening*
*NOTE: To be used
on custom hood
when controls are
remotely mounted.
30 ft. of 4-wire cord
(straight-pinned)
with connector
NOTE: Not for
telecommunications
(telephone) network.
Installation Preparation
5 nuts for damper plate
assembly
(not located in hardware
bag–you must save nuts
when you remove damper
plate from inset hood
while unpacking parts)
6 insert sleeve chassis
plugs, 1 (optional) house
wire hole plug, 2 rubber
grommets, 4 insert sleeve
washers
Control wall bracket
Control Control
mounting mounting
plate bracket
2 mounting plate
2 wall
screws
bracket
screws
Hood liner (packed in
separate carton)
Insert sleeve
(Models ZVC30LSS and ZVC36LSS)
11
Filters
Blower motor
Dual blower motor
(Model ZVC48LSS)
Damper plate