Table of Contents
Advertisement
Changing the charge fuse
The charge fuse is on the underside of the
chassis, over the right rear wheel, next to the
circuit breaker, see fig. 49. Switch off the main
circuit breaker and the charger, if in use, before
you change the charge fuse.
NB! The circuit breaker must be in the "ON" position
during charging.
Changing the seat/lights fuse
There are two fuses in the SLS drive stage,
F1 (24V unswitched) and F2 (24V switched).
These protect two outlets, located to the left of the
SLS drive stage, next to the charge socket. One of
the outlets (24V unswitched) supplies power
regardless of whether the chair is switched on or
off. The other outlet (24V switched) supplies power
only when the chair is switched on. The seat and
lights are normally connected to this outlet.
1. Detach the seat lift and chassis covers,
see page 8.
2. Switch off the power using the control panel.
3. Set the main fuse to the "OFF" position,
see page 20.
4. Lift up the SLS box, which is sitting loose
in its holder, see fig. 45.
5. Pull the cover off the SLS box.
6. Replace broken fuses, see Fig. 46
7. Put the cover back on the box.
8. Put the SLS box back into its place on
the chassis.
9. Remount the covers.
10. Put the circuit breaker in the "ON" position,
see page 20.
Fig. 44. Charge fuse
Fig. 45. SLS driver sits loosely in its holder.
F1
Fig. 46. F1 = 24V unswitched 15A.
F2 = 24V switched 15A Seat/Lights.
21
Circuit breaker and fuses
F2
Advertisement
Table of Contents
