TA-S9D
5-1.
NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
Note on Printed Wiring Boards:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
•
: internal component.
f
•
: Pattern from the side which enables seeing.
• Indication of transistor.
Q
B
C E
These are omitted.
• Circuit Boards Location
AC OUTPUT board
PANEL board
10
SECTION 5
DIAGRAMS
SURROUND AMP board
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1
/
W or less unless otherwise
4
specified.
•
: internal component.
f
• 2 : nonflammable resistor.
• 5 : fusible resistor.
• C : panel designation.
Note: The components identified by mark 0 or dotted line
with mark 0 are critical for safety.
Replace only with part number specified.
• A : B+ Line.
• B : B– Line.
• Voltages are dc with respect to ground under no-signal
conditions.
no mark : Power on
(
) : Output is more than 1 W.
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Signal path.
F
: AUDIO
N
: MIC
• Abbreviation
AUS : Australian model
EA
: Saudi Arabia model
KR
: Korean model
MX
: Mexican model
SP
: Singapore model
TH
: Thai model
SUB TRANS board
AC INPUT board
FRONT AMP board
RELAY board