Advertisement
Ref : MP_QUEST
KAYAK HOBIE QUEST
OWNER'S MANUAL
Montage des options - Installation d'un porte-canne
Illustration
(Note: Quest Fisherman packages have the rod holder base preinstalled)
The center console in the Hobie Quest is designed to accommodate a deck mounted rod holder. If you are using the
rod holder from Hobie, follow the instructions below.
Copyright HCE 2011 - www.hobie-cat.net
Issued by : IR
Date : 12/2011
Steps Description
Up-date : 0
Your Hobie rod holder kit comes with the following items:
•
One Rod Holder Base
•
One Baitcaster Rod holder
•
Four Screws
•
Four Lock Nuts
1. Sit in the kayak and find the best position for the rod holder.
Using the rod holder as a guide, drill a 1/4" hole through the
top of the console in the 4 locations for screws.
2. Open the large flip-up hatch and reach inside the kayak.
Place the screws through the rod holder base, through the
holes you just drilled and place the lock nuts on the screws.
Tighten the nuts onto the screws and you're ready to go.
Page : 9/16
Advertisement
