Advertisement
Ref : MP_QUEST
KAYAK HOBIE QUEST
OWNER'S MANUAL
Assembly manual - Rudder kit
Illustration
The Hobie Quest is designed for the addition of an optional rudder system. Rudder systems in boats like this allow you to
adjust the steering trim of your boat when paddling in high wind or strong current conditions. If you purchased the Quest
with the rudder package installed, continue reading for rudder installation and operation. If you bought the rudder kit as
an installation option, consult the instructions that come with the rudder kit.
Copyright HCE 2011 - www.hobie-cat.net
Issued by : IR
Date : 12/2011
Step
1
2
4
Up-date : 0
Description
Installing the Rudder-Bracket
There are two molded in inserts at the stern of the boat that
are intended for mounting the rudder bracket. If your boat has
seen some use prior to installing the bracket, be sure to wash
out the holes in the inserts to remove any sand that may have
collected in the threads.
•
Orient the bracket on the back of the boat with the longer
bend of the bracket at the top.
•
Using a screwdriver, thread in the screws until the bracket
is tight against the hull.
Mounting the rudder
Remove the screw and washer from the bottom of the rudder
pin and slide the pin into the bracket mounted on the stern of
your boat.
Install the washer and screw back onto the bottom of the rud-
der pin, making sure it is nice and tight. Check the tightness of
the screw from time to time to be sure it is secure.
Run the black line at the top of the rudder up to the cockpit and
tie it to the padeye that your seat snaps to. This will keep the
up-and-down control line of your rudder close by at all times.
Page : 6/16
Advertisement
