Volvo S80 Owner's Manual page 217

LDW displayed in the instrument panel
•
The LDW symbol has white side marker
lines: – the function is active and "sees"
one or both of the road's side marker
lines.
•
The LDW symbol has gray side marker
lines: – the function is active but cannot
"see" one or both of the road's side
marker lines.
or
•
The LDW symbol has gray side marker
lines: – the function is in standby mode
because the vehicle's speed is below
40 mph (65 km/h).
•
The LDW symbol has no side marker
lines: – the function is deactivated.
WARNING
The driver will only be warned once for
each time the wheels cross a marker line.
No alarm will be given if a marker line is
between the wheels.
Settings
Settings for Lane Departure Warning can be
made in the menu system by pressing My
Car. Go to Settings Car settings
Driver support systems Lane Departure
Warning.
There are two alternatives:
•
On at start-up : This selection switches
LDW on each time the engine is started.
Otherwise, the system will be in the mode
that it was in when the engine was
switched off.
•
Increased sensitivity
: This selection
increases the function's sensitivity. Warn-
ings will be given at an earlier stage and
fewer limitations apply. When this setting
is being used, the system only needs to
monitor lane marker lines on one side of
the vehicle to change status to
Depart Warn Available .
Related information
•
Driver Alert System (p. 209)
•
Lane Departure Warning (LDW) – symbols
and messages (p. 217)
07 Driver support
•
Lane Departure Warning (LDW) – intro-
duction (p. 214)
•
Lane Departure Warning (LDW) - limita-
tions (p. 216)
Lane
07
215