Loading/Threading The Film - Linea DH-360 Product Instruction Manual

Loading/threading the film - Encapsulating
Please follow the step by step guide below to correctly load your film;
Remove the safety guard
Remove the top mandrel
Core holder located on mandrel
Thread film from top mandrel down
under top idler bar and over top
laminating roller surface as shown
(ensure film is loaded with
adhesive side up)
6
Remove the feed tray by retracting the bolt
Completely unscrew the mandrel
and cap
Load the film onto the mandrel and
make sure it is loaded with the film
coming off the bottom of the roll with
the adhesive side up. Tighten the screw
back up with screwdriver provided
Load film onto bottom mandrel in
the same fashion as with the top
mandrel, remove bottom mandrel as
shown
NOTE: Indents are drilled in the
mandrels to locate core holder so
top and bottom films line up
Refit the mandrel complete with
the loaded film
Move bottom stabilizer bar forward
to assist film loading