Operating Instructions - Linea DH-360 Product Instruction Manual

Speed control
The speed control function allows adjustment of the speed of the machine. This can be manually
adjusted by turning the knob anti clockwise to increase the speed and clockwise to decrease the
speed. The speed can range from 0M per min to 1.4M per min
Hot and cold settings
To change the function of the machine to either hot or cold press the HOT/COLD switch. When it is
switched to hot the set temperature will show on the LCD display. When it is switched to cold, COLD
will show on the LCD display.
Forward and reverse switch
The FWD/REV switch changes the working direction of the motor. When it is switched to forward
the motor will run forward and
laminating and encapsulating.
When it is switched to reverse the motor will run backwards and REVERSE will show on the
LCD display. This function is used to remove items fed in incorrectly or by mistake - please note
removed items will not be reuasable
Run and stop switch
The RUN/STOP switch enables you to start and stop the motor. When it is switched to RUN the
machine will

Operating instructions

Ensure the laminator is placed on a flat, sturdy work surface or on the assembled stand (optional extra). Check the
power voltage for the machine to ensure this meets your own supply. Plug the power cord into the back of the
machine and into your power supply. Contact your supplier if you do not have a power cord with the machine.
Motor overload circuit breaker
If the machine should jam in a way that the motor could be effected, the circuit breaker will cut off the power
to avoid damage. Once the overload has been cleared, press the circuit breaker button and the motor will start
again. The circuit breaker button is located at the rear of the machine next to the power switch. The button is red
in colour.
will show on the LCD display. This function is used for
Turn on the power switch, the control panel display will
light, this indicates the power is connected.