Operation - Central Pneumatic 98898 Set Up And Operating Instructions Manual

1. Depending on the size of rivet pin used, attach the corresponding Nosepiece size
(1/4", 1/8", 5/32", or 3/16") with the accessory Spanner Wrench (36).
2. iMpOrtant: When drilling rivet holes in a workpiece, make sure to use the same
diameter drill bit as the outer diameter of rivet sleeve you will be using.
3. Turn on the air compressor, and set its regulator between 90-120 PSI.
Do not exceed 120 pSi.
4. Insert the pin (long, thin end) of a rivet fully into the Nosepiece (1). Insert the
sleeve (short, thick end) of the rivet through the pre-drilled hole in the workpiece.
Do not touch the trigger (25) when you are inserting rivets.
5. Hold the Riveter firmly with both hands, and squeeze the Trigger (25) to activate
the Riveter. Repeat as necessary. Then, release pressure on the Trigger. See
Figure B.
6. When finished using the Riveter, turn off the air compressor. Squeeze the Trigger
(25) again to release any compressed air in the Riveter. Then, disconnect the air
hose from the tool.
SKU 98898 For technical questions, please call 1-800-444-3353.

OperatiOn

REV 08j
Page 5