Compaq Evo D500 Technical Reference Manual page 98

Chapter 4 System Support
4.8.3.2 I/O Controller Miscellaneous Functions
The systems covered in this guide utilize the following specialized functions built into the LPC
47B357 I/O Controller:
♦
Power/Hard drive LED control – The I/O controller provides color and blink control for the
front panel LEDs used for indicating system events as listed below:
System Status
S0: System on (normal operation)
S1: Suspend
S3: Suspend to RAM
S4: Suspend to disk
S5: Soft off
Processor not seated
CPU thermal shutdown
ROM error
Power supply crowbar activated
System off
NOTE:
[1] Later systems using PCA#s 011305, 011308, or 011311 will power down for this condition.
♦
Intruder sensing – Used on Small Form Factor and Slim Desktop models, battery-backed D-
latch logic internal to the LPC47B357 is connected to the hood sensor switch to record hood
(cover) removal.
♦
Hood lock/unlock – Used on Small Form Factor and Slim Desktop models, logic internal to
the LPC47B34x controls the lock bar mechanism.
♦
I/O security – The parallel, serial, and diskette interfaces may be disabled individually by
software and the LPC47B357's disabling register locked. If the disabling register is locked, a
system reset through a cold boot is required to gain access to the disabling (Device Disable)
register.
♦
Processor present/speed detection – One of the battery-back general-purpose inputs (GPI26)
of the LPC47B357 detects if the processor has been removed. The occurrence of this event is
passed to the ICH2 that will, during the next boot sequence, initiate the speed selection
routine for the processor. The speed selection function replaces the manual DIP switch
configuration procedure required on previous systems.
♦
Legacy/ACPI power button mode control – The LPC47B357 receives the pulse signal from
the system's power button and produces the PS On signal according to the mode (legacy or
ACPI) selected. Refer to chapter 7 for more information regarding power management.
Compaq Deskpro and Evo Personal Computers
4-42
Featuring Intel Celeron and Pentium III Processors
Power LED
Steady green
Blinks green @ 1 Hz
Blinks green @ 1 Hz
Blinks green @ 0.5 Hz
Off - clear
Steady red
Blinks red @ 4 Hz [1]
Blinks red @ 1 Hz
Blinks red @ 0.5 Hz
Off
Fifth Edition – March 2002
HD LED
Green w/HD activity
Off
Off
Off
Off
Off
Off
Off
Off
Off