Weak Or Hard To Hear Audio - Uniden XDECT SSE25 Series Owner's Manual

If...
The answering system
does not work.
The answering
system won't record
messages.
My outgoing message
is gone.
I can't hear the base
speaker.
Messages are
incomplete.
The answering system
keeps recording
when I answer on an
extension.
I can't register a
handset.

Weak or Hard To Hear Audio

If a caller's voice sounds weak or soft, the signal might be blocked by
large metal objects or walls; you might also be too far from the base, or the
handset's battery may be weak.
 Try moving around while you're on a call or moving closer to the base
to see if the sound gets louder.
 Make sure the handset's battery is fully charged.
 Try adjusting the volume of the earpiece or the audio tone (see below).
Adjust the audio tone
During a call, press
High Tone, Natural Tone (recommended for hearing aid users), or Low
Tone. (The tone setting appears in the display as you do this.) You may
have to experiment to figure out which audio tone works best for you.
XDECT SSE25 OM.indd 23
Try...
Making sure the answering system is turned on.
-
Making sure the base AC adapter is plugged into a
-
continuous wall outlet (i.e., not controlled by a wall
switch).
Making sure the
-
Announce Only.
Deleting saved messages (the memory may be full).
-
Seeing if there was a power failure. You may have
-
to re-record your personal outgoing message.
Making sure call screening is turned on.
-
Changing the base speaker volume.
-
The incoming messages may be too long. Remind
-
callers to leave a brief message.
Deleting saved messages (the memory may be full).
-
You may have to change the line mode. Visit the
-
website for more information.
Seeing if you already have 6 handsets registered to
-
this base.
Resetting the handset.
-
to cycle through the three audio tone options:
TONE
Record Time is not set to
23
23/12/09 11:17:57 AM