Weak Or Hard To Hear Audio; Noise Or Static On The Line - Uniden DECT2015+2 Owner's Manual

When you have this
problem...
I can't get two handsets to
talk to an outside caller.
The new message LED
(Voice Mail Waiting Indicator)
flashes, but there are no new
messages.

Weak or Hard to Hear Audio

If the caller's voice sounds weak or soft, the signal might be blocked by large metal objects or walls; you might also
be too far from the base, or the handset's battery may be weak.
• Try adjusting the volume of the earpiece (see page 36) or the audio tone (see page 37).
• Try moving around while you're on a call or moving closer to the base to see if the sound gets louder.
• Make sure the handset's battery is fully charged.

Noise or Static on the Line

The most common cause of noise or static on a cordless phone is interference: other wireless or electronic devices
can radiate energy that disturbs the radio signal between the base and the handset (much like overhead power lines
can cause static on your car radio). Some common household sources of interference are
• electrical appliances, especially microwave ovens
• computer equipment, especially wireless LAN equipment and DSL modems
• radio-based wireless devices, such as room monitors, wireless controllers, or wireless headphones or speakers
• large florescent light fixtures (particularly ones that give off a "buzzing" noise)
• other services that use your phone line, like alarm systems, intercom systems, or broadband Internet service
DECT 2015+1 OM.indb 50
• Checking to see that there are not two handsets already using the conference
feature (see page 38).
• Making sure another handset is not in Privacy Mode (see page 40).
• Making sure both handsets are registered to and currently connected to the same
base (see pages 14 and 15).
• Resetting the Voice Mail Waiting Indicator (see page 43).
50
Try...
7/7/08 12:31:11 PM